Step-1 Push

Use a cuticle pusher (like the one in the picture) to gently push back the cuticles on your natural nails.

Step-2 Trim

Choose a dead skin fork and gently trim the cuticles of your fingers. This is because pushing the cuticle back helps keep your nails clean and can prevent problems such as ingrown nails.

Step-3 File

File your nails, roughens the surface of nails.The purpose is to allow the jelly glue or adhesive to adhere better to the nail, ensuring a tight fit and making the nail wear last longer.

Step-4 Clean

Always make sure to thoroughly clean any dust from your nails, as the powder from sanding can seriously affect the strength of your nail wear.

Step-5 Option

Measure and choose the right size of jelly glue for your nail bed (it is best if the jelly gel size is slightly smaller than the width of the nail).

Step-6 Apply

Apply jelly glue to your nails.

Step-7 Peel

Peel off the kraft paper and let out the clear jelly glue part inside.

Step-8 Apply

Place the press - on nails at a 45-degree angle on the jelly gel, push down and then press the nail with your finger for 2-3 minutes.

Step-1 Take off

Using the beveled side of a cuticle pusher, gently insert it through the side of the nail edge and pry open a small opening, gradually widening the gap. Treat the area around the nail in this manner until the entire nail can be easily pushed off.

Step-2 Clean up

After removing the nail, tear off any remaining jelly glue. For the remaining gel on the nail, carefully roll it off with the tip of a small stick and wipe it off with a clean cotton pad for the next use.